Trigger Settings

Scan Mode

Users can set the reading mode of the Scan Engine according to their needs. The default state is the button trigger mode. In this mode, the Scan Engine starts reading after pressing the Trigger Button, and stops reading after successful reading or releasing the Trigger Button.

* Key Trigger

Users can also set the Scan Engine to automatic continuous reading mode. After the setting is successful, the red light of the Scan Engine is always on. When a barcode passes by, the Scan Engine automatically reads the barcode. The same barcode will not be read again unless it is removed and read again.

Automatic Continuous Reading

Discontinuous Reading

You can also set the Scan Engine to Button Delay Mode. In this mode, the red illumination remains on for 3 seconds and turns off when the timeout expires without a successful read or when a barcode is read successfully.

Key Delay

Key Delay Parameters

Key Timeout

When the user uses the key delay mode, the user can set the decoding timeout according to the needs. The default is 3 s and the time range is 1-9.9 s.

Timeout 1 S

* Timeout 3 S

Timeout 5 S

Timeout 9.9 s

Self-sensing Settings

* Disable IR Auto-sensing

Enable IR Auto-sensing

Self-sensing Sensitivity And Interval Time Parameters

Format

0265 + sensitivity setting + interval setting

Sensitivity

0x01 to 0xFF, the smaller the value, the higher the sensitivity.

Scan Interval

0x01 to 0x40.

Example

02657705 means the sensitivity is 0x77 and the interval is 0x05 (500 ms).

Self-sensing Sensitivity And Interval Time Setting Example

inverse reading Settings

Enable inverse reading

* Disable inverse reading

inverse reading Settings

Duplicate Code Detection Settings

* Disable Duplicate Code Detection

Enable Duplicate Code Detection

The Re-coding Interval Is 1s

The Re-code Interval Is 2s

The Re-code Interval Is 3s

The Re-coding Interval Is 5s

The Re-coding Interval Is 10s