System Settings#
Input/output settings#
Introduction#
This chapter mainly introduces the configuration of the buzzer and LED when the Barcode Reader is powered on, decoded, and button triggered.
Power on beep setting#
Power-on beep, that is, after the Barcode Reader is successfully powered on, it can sound a buzzer to prompt it to enter the working state. According to the needs of the scene, it can also be configured to have no beep. Default value = there will be a beep when power on successfully.
No beep after successful power-on#
* There will be a beep after successful power-on.#
Trigger decoding sound settings#
After triggering the decoding switch, regardless of whether it is decoded or not, the Barcode Reader can emit a tone to indicate that the switch has been triggered. Default value = no beep when triggering decoding switch
* No beep when triggering decoding switch#
There is a sound when triggering the decoding switch.#
Setting the beep after successful decoding#
Good Decode beep response setting#
After the decoding is successful, the buzzer will sound to indicate that the decoding is successful. If a beep is not required, it can be configured to have no beep after the decoding is successful. Default value = beep after successful decoding.
No beep after successful decoding#
* There will be a beep after successful decoding.#
Good Decode sound volume setting#
Scan the following barcode to modify the beep volume of the Barcode Reader after successful decoding. Default = high.
Low#
Medium#
* High#
Disable#
Good Decode beep frequency setting#
Scan the following barcode to modify the beep frequency of the Barcode Reader after successful decoding. The default value is medium.
* Medium (2400 Hz)#
Low (1600 Hz)#
High (4200 Hz)#
Good Decode beep duration setting#
Scan the following barcode to modify the beep duration of the Barcode Reader after successful decoding. Default=Normal.
*Normal beep#
short beep#
Decoding failure beep frequency setting#
Scan the following barcode to modify the beep frequency of the Barcode Reader after decoding failure. Default=Razz.
\* Razz (250 Hz)#
Medium (3250 Hz)#
High (4200 Hz)#
code reading delay#
Scan the following barcode to set the time interval between the Barcode Reader reading one barcode and then reading the next barcode. Default=750 ms.
No delay#
* Short delay (750 ms)#
Medium latency (1,000 ms)#
Long delay (1,500 ms)#
Common functions#
Factory Default Settings#
If you want to apply default settings to your Barcode Reader, scan the “Load Factory Default Settings” barcode below to reset your Barcode Reader to factory default settings.
Load factory default settings#
Firmware version display#
Scanning the following barcode will output the current firmware version, unit serial number and other product information.
Show version information#